电力工业标准-电力网-万方数据知识服务平台

1 实验室玻璃器皿颜色代码和颜色标志用色釉的化学稳定性测定方法 - 摘要

Test methods for determining the service performance of enamels are specified, i.e. for determining whether an enamel resists the specified treatment. The procedure insolve treatment for specified periods with an alkine detergent at 80 degrees centigrade and a dilute acid solution at room temperature.
ISO 4794-1982 - 中外标准 - ISO- 1982/1 - 现行
关键词：作标记耐化学性搪瓷实验室器具玻璃器皿涂料实验室玻璃器皿耐化学性试验玻璃釉层实验室器皿颜色试验耐力移液管色码 Chemical resistance Chemical-resistance tests Colour Colour codes Enamels Glass Glassware Laboratory apparatus Laboratory glassware Laboratory ware Marking Paints Pipettes Resistance Testing Tests Vitreous enamel

2 煤气设备.实验室用煤气喷灯(实验室燃烧器) - 摘要

Gas-appliances; gas-burners for laboratory use (laboratory burners)Diese Norm enth?lt in den Abschnitten 4, 5 und 7 sicherheitstechnische Festlegungen im Sinne des Gesetzes über technische Arbeitsmittel (Ger?tesicherheitsgesetz), siehe Erl?uterungen.Die
DIN 30665-1-1982 - 中外标准 - DINBASE- 1982/1 - 现行
关键词：燃气燃烧器实验室器皿安全工程实验室装备讲授燃烧器规范(审批) 作标记定义尺寸实验室实验室用燃烧器气体 Burners Definition Definitions Dimensions Gas burners Gases Laboratories Laboratory furniture Laboratory ware Marking Safety engineering Specification (approval) Teaching

3 试验室用离心机.相对离心加速度在4000以下的离心机管 - 摘要

Laboratory centrifuges; centrifuge tubes for relative centrifugal acceleration up to 4000
DIN 58970-2-1982 - 中外标准 - DINBASE- 1982/1 - 现行
关键词：材料实验室装备离心机实验室器皿尺寸定义医学科学实验室设计公差 Centrifuges Definition Definitions Design Dimensions Laboratories Laboratory furniture Laboratory ware Materials Medical sciences Tolerances (measurement)

4 膜过滤器的可高压消毒性的标准试验方法 - 摘要

These test methods provide information on the dimensional stability and wetting characteristics of autoclaved membrane filters. Excessive dimensional changes caused by autoclaving a constrained membrane filter could crack the filter, rendering it useless. Increased hydrophobicity, due to autoclaving would result in an increased time to filter a liquid sample.
1.1 These test methods deal with tests to determine the autoclavability of membrane filters.

1.2 These test methods are applicable to all membrane filters. Either Test Method A, Test Method B, or both, may be utilized to assess the autoclavability of membrane filters.
ASTM D4199-1982(2011) - 中外标准 - ASTM- 1982/1 - 现行
关键词：autoclavability filter membrane Autoclaves Dimensional stability Membrane filters (MF)--water testing Sterilization--water analysis Wet testing

5 膜过滤器的可高压消毒性的试验方法 - 摘要

These test methods provide information on the dimensional stability and wetting characteristics of autoclaved membrane filters. Excessive dimensional changes caused by autoclaving a constrained membrane filter could crack the filter, rendering it useless. Increased hydrophobicity, due to autoclaving would result in an increased time to filter a liquid sample.
1.1 These test methods deal with tests to determine the autoclavability of membrane filters.
1.2 These test methods are applicable to all membrane filters. Either Test Method A, Test Method B, or both, may be utilized to assess the autoclavability of membrane filters.
Section
Test Method A-Dimensional Stability 8.1
Test Method B-Wetting Characteristics 8.2
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D4199-1982(2003) - 中外标准 - ASTM- 1982/1 - 现行
关键词：水试验过滤机薄膜材料膜过滤器高压釜 autoclavability filter membrane

6 评估细菌分析和生长用的和膜过滤器一起使用的吸收性垫片的标准试验方法 - 摘要

These test methods are appropriate for qualifying absorbent pads used with membrane filters for bacteriological enumeration.

The test methods described are applicable to quality control testing of absorbent pads by the suppliers and users of these pads and to specification testing of absorbent pads intended for use with membrane filters in bacteriological enumeration.

Other pure culture organisms and their appropriate culture medium may be substituted for the E. coli and M-FC media for specification testing, as required.
1.1 These test methods cover the determination of the nutrient-holding capacity and the toxic or nutritive effect on bacterial growth of organisms retained on a membrane filter, when the absorbent pad being tested is used as a nutrient reservoir and medium supply source for the retained bacteria.

1.2 The tests described are conducted on 47-mm diameter disks, although other size disks may be employed for bacterial culture techniques.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D4198-1982(2011) - 中外标准 - ASTM- 1982/1 - 现行
关键词：absorbent pads bacteriological filter membranes Sterilization--water analysis Toxicity/toxicology--water environments Nutrient holding capacity Absorbent materials/applications Bacteria/bacterial control--water Membrane filters (MF)--water testing Microorganisms

7 细菌分析和生长用的和膜过滤器一起使用的吸收性垫片的评价方法 - 摘要

These test methods are appropriate for qualifying absorbent pads used with membrane filters for bacteriological enumeration.

5.1.1 The test methods described are applicable to quality control testing of absorbent pads by the suppliers and users of these pads and to specification testing of absorbent pads intended for use with membrane filters in bacteriological enumeration.

Other pure culture organisms and their appropriate culture medium may be substituted for the E. coli and M-FC media for specification testing, as required.
1.1 These test methods cover the determination of the nutrient-holding capacity and the toxic or nutritive effect on bacterial growth of organisms retained on a membrane filter, when the absorbent pad being tested is used as a nutrient reservoir and medium supply source for the retained bacteria.

1.2 The tests described are conducted on 47-mm diameter disks, although other size disks may be employed for bacterial culture techniques.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D4198-1982(2003) - 中外标准 - ASTM- 1982/1 - 现行
关键词：分析膜过滤器吸收细菌学薄膜材料过滤机水背衬 absorbent pads bacteriological filter membranes

8 过滤量瓶规范 - 摘要

Filter flasks, Flasks (laboratory), Conical flasks, Laboratory glassware, Glassware, Vacuum filtration, Shape, Dimensions, Volume, Marking, Differential pressure, Pressure testing, Hydraulic tests, Test equipment
BS 1739-1982 - 中外标准 - BSBASE- 1982/1 - 废止
关键词：体积玻璃烧瓶实验室器皿过滤量瓶尺寸实验室玻璃器皿建筑规范容量玻璃器皿 Capacity Construction Dimensions Filter flasks Glass flasks Glassware Laboratory glassware Laboratory ware Specifications Volume

9 颈部有刻度的烧瓶(苯酚型)规范 - 摘要

Specifies a 45 ml flask for the polymerization test specified in BS 244 and 290, a 150 ml flask for the determination of phenols in essential oils by the official SAC method and a 250 ml flask for the determination of phenols in oils by the STPTC method.
BS 676-1982 - 中外标准 - BSBASE- 1982/1 - 现行
关键词：作标记实验室玻璃器皿标准温度划刻度聚合油容量瓶酚类容积测量尺寸形状玻璃器皿化学分析和试验烧瓶(实验室) 含量测定 Chemical analysis and testing Determination of content Dimensions Flasks (laboratory) Glassware Graduations Laboratory glassware Marking Oils Phenols Polymerization Shape Standard temperature Volume measurement Volumetric flasks


	Section
Test Method A-Dimensional Stability	8.1
Test Method B-Wetting Characteristics	8.2

火力发电

环境保护

电站锅炉

汽轮机

汽轮发电机

热工控制

水力发电

水电站类型

水工建筑物

主要坝型

水电站主要设备

智能水电厂

核能发电

反应堆

核电设备

核电安全

风力发电

风电场

风电机组

风电设备

运行方式

光伏发电

核心设备

电网影响

光伏应用

电力输送

高压直流输电(HVDC)

柔性输电

输电线路

保护及重合闸

变电系统

一次设备

二次设备

变电站继电保护

智能变电站

变电站分类

研究专题

配电网

主要设备

关键技术

配电自动化

接地方式

故障及分析方法

设计规划

电源及负荷规划

电网规划设计

计算和分析

无功补偿和电压调整

经济性

电力行业论文

能源、技术类论文

经营管理类论文

相关论文

电力行业期刊

行业学会/协会/企业刊物

电力期刊按学科分类

电力期刊按行业分类

电力行业成果

电力行业成果学科分类

电力行业专利

电气工程

热力工程

水利工程

转动机械

燃料、化学

信息通讯

其他相关专利

电力工业标准

能源、核技术

电工

电子与信息技术

仪器仪表

工程建设

其他相关行业

电力行业机构

电力企业

采矿业

制造业

展开标准分类

展开标准类型