知识导航
采矿工艺
选矿工艺
烧结工艺
高炉炼铁
电炉炼钢
转炉炼钢
连续铸钢
轧钢工艺
资源分类
冶金期刊
冶金工业论文
冶金工业成果
冶金工业标准
冶金
- > 冶金综合
- > 金属化学分析方法
- > 金属理化性能试验方法
- > 冶金原料与辅助材料
- > 钢铁产品
- > 有色金属及其合金产品
- > 粉末冶金
- > 半金属与半导体材料
- > 冶金机械设备
矿业
机械
环境保护
- > 环境保护综合
- > 环境保护采样、分析测试方法
- > 环境质量标准
- > 污染物排放标准
其他相关行业
冶金工业专利
连铸板坯全冶金长度凝固形貌 2017年12月16日 【正式出版版本】 【曾经优先出版版本】
连铸板坯全冶金长度凝固形貌
Solidification morphology for full metallurgical length of continuous casting slab 2017年12月16日 【正式出版版本】 【曾经优先出版版本】
Solidification morphology for full metallurgical length of continuous casting slab
-
摘要： - 采用移动边界法计算低碳钢连铸板坯全冶金长度温度场,利用CAFE耦合模型模拟其凝固行为,考察过热度和拉坯速度对板坯宽面中心温度、横断面微观组织形貌及二次枝晶臂间距等影响,并计算二次枝晶臂间距与冷却速度关系及碳元素中心偏析.研究结果表明:过热度和拉坯速度降低均能使宽面中心温度和中心二次枝晶臂间距下降,而拉坯速度的影响更为显著;拉坯速度越高中心等轴晶率越高,晶粒半径越小,利于提高连铸板坯质量,过热度对中心等轴晶率及晶粒半径影响较小;二次枝晶臂间距在固液两相区生成并增大,二次枝晶臂间距与冷却速度之间呈指数关系;连铸板坯中心偏析区域呈岛状分布在中心线上,最大偏析指数为1.14,中心部位负压抽吸临近枝晶间富积溶质钢液导致中心线附近形成负偏析.
-
Abstract： - Steel solidification for continuously cast low carbon slab was calculated using a coupled model of CAFE in combination with the temperature distribution in the full metallurgical length, which was predicted by the moving boundary method. Further, the influences of steel superheat and casting speed on the central temperature of slab wide-surface, morphology of slab section and secondary dendritic arm spacing were investigated, and the relationship between arm spacing and cooling rate of steel as well as the central carbon segregation of slab were analyzed. The results show that the decreases of superheat and casting speed lead to the reductions of central temperature and arm spacing, and the impact from casting speed is more significant. Ratio of equiaxed zone increases with casting speed and the grain radius decreases, and it is conducive to improve the continuous casting slab quality, while the superheat does not have significant effect on casting speed and grain radius. Secondary dendritic arm spacing is formed and increased in mushy zone, and it presents an exponential trend with cooling rate. Central carbon segregation distributes in the central line of slab in the form of islands, and the maximum segregation index reaches 1.14. Enriched solute elements around the dendrites are pumped into the steel by negative pressure and then generate the negative segregation.
|
|
王鑫
孟祥宁
黄烁
朱苗勇
|
|---|---|
| Author： | WANG Xin MENG Xiangning HUANG Shuo ZHU Miaoyong |
|
|
东北大学冶金学院,辽宁沈阳,110819 |
|
|
中南大学学报（自然科学版） ISTIC EI SCI PKU CSSCI |
|
|
Journal of Central South University（Science and Technology) ISTIC EI SCI PKU CSSCI |
|
|
2017, 48(12) |
|
|
TF777 |
|
|
连铸板坯
宽面中心温度
微观组织形貌
二次枝晶臂间距
碳偏析
|
|
|
continuous casting slab center temperature of wide surface morphology secondary dendritic arm spacing carbon segregation |
|
|
|
|
|
2018年1月23日 |
|
|
国家自然科学基金资助项目，中央高校基本科研业务费资助项目(N140205002)(Project(51004031) supported by the National Natural Science Foundation of China，Project |
返回顶部参考文献
返回顶部引证文献
返回顶部本文读者也读过
返回顶部相似文献
返回顶部相关博文
京公网安备11010802020237号